| Vendor Technologies |
77A Air Angle Grinders, Sanders and Polishers are designed for smoothing, trimming or removing metal in close-quarter areas in foundries, shipyards, steel mills and in construction application.
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Mechanical Cutting Equipment > Abrasive Cutter
|
Chipping Hammers are designed for trimming castings, billets, bars and plates in foundry applications, for removing weld bead and trimming plates in shipyards and car shops and for concretes roughing
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Non-Cutting Methods > Controlled Blasting
|
The chipping hammer is a pneumatic chisel used to remove lead sheeting from the external surfaces of the glove box and tank.
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Non-Cutting Methods > Chipping Hammer
|
The hydraulic shear is a two-bladed or two-cutter tool that operates on the same principle as a conventional pair of scissors. A bladed shear primarily is used for inline cutting of sheet metal. The
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Mechanical Cutting Equipment > Abrasive Cutter
|
The hydraulic shears or mega cutter AMK-HP60 is a portable heavy-duty tool with a maximum cutting force of 67,900 lbs and with a maximum cutter opening of 8 in. The operating pressure is 10, 500 psi
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Mechanical Cutting Equipment > Mobile Shears
|
The In-Situ Underwater Gamma Spectroscopy system (ISUGS) uses existing instrumentation and computer software developed by Canberraadapts it for use as a submersible unit, and modifies the efficiency c
More Information
Source :
TMS Technology Database
Category :
Characterization > Monitors > Radiation Monitors
|
The oxy-acetylene torch is a basic thermal cutting technique that can be used on carbon steel up to 3-4" thick. Cutting speeds up to about 10 inches per minute (as per the vendor-supplied information)
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Non-Mechanical Cutting Equipment > Oxyacetylene/Oxygasoline Cutting
|
The PCH/M-80 Torch provides cutting capacity of up to I inch (25.5 mm) at 80 amperes. In the torch, a single torch lead provides compressed air or nitrogen (N2) from a single source to be used as bot
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Non-Mechanical Cutting Equipment > Plasma Arc
|
The plasma arc torch is a powerful thermal cutting method that can be used where oxy-acetylene cutting is not applicable (i.e., stainless steel, aluminum, copper, and other non-oxidizing metals). Plas
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Non-Mechanical Cutting Equipment > Plasma Arc
|
The pneumatic cutoff tool is an air-powered, hand-held, abrasive cutoff wheel. The tools come in a variety of sizes and can be adapted to cut most materials with the selection of the appropriate grind
More Information
Source :
Applied Research Center (formerly HCET)
Category :
Dismantlement > Mechanical Cutting Equipment > Abrasive Cutter
|
| 1 |